Recent content by TFro3

This is amazing! Welcome and good luck! You got this!

Can you post a screenshot of the error(s) as well as the changes you made? Sounds like it may just be a simple syntax fix.

Hey @Neezus333! You are correct! The VCC connects to your Raspberry Pi 5v power and Ground on the relay connects to an open Ground pin on your Raspberry Pi!

Most definitely! Great Tip(s)!

Cheapest would be a DIY option if you have access to a local hardware store

I used an Ender3 v2 for these towers. Since then I upgraded to more higher end machines but you don’t need anything fancy! Other materials were from a local hardware store

Nope! They’ll be fine on direct sun. The plants will love it for sure. Just make sure when temps are high to shorten the off interval for the pump!

Should be something I can whip up this weekend.

Hey @mrbrownstarfish! When you say 3" net pot holder, are you referring to the pipe diameter or the diameter of the actual net cup?

When using this flange setup you can also use a piece I just uploaded to Printables which is a tube support that's secured externally rather than internally to make setup a little easier since it can be difficult to line up screw holes and such when the part is inside the PVC pipe. (see...

So you have or are thinking about a MUFGA countertop hydroponic unit, right? Well cool! The documentation that comes with these units isn't the best so this is a little informational section that I put together to hopefully help answer questions and alleviate stress/unknowns! If you're also...

I could probably remix that cup to fit this design. I can work on that for you for sure. And yeah, I would use filament that's dark. Light getting into the root area will cause algae which is not good.

Strawberries like something like 5 minutes on and 45 minutes off.

Hello there!! Excellent question. Is this setup indoors or outdoors? By the temperature mentioned I’d assume outdoor? I run my lettuce that grows outdoors 1 minute in and 5 minutes off.

Welcome!!